Planter with dowel Legs

thingiverse

This is a Planter planned to use 1 inch dowel legs with a 60 Degree cut to fit in the printed model. The print does not need supports and is printed in Vase Mode. Files: - Planter with no Draining holes to be used with a 6" plastic planter and fill the bottom with pebbles to prevent humidity excess. - Planter with Draining holes - Drain Plate - 60 Degrees 1 inch Dowel Jig for flush trim saw - 280mm 3d Printed Leg to be adjust as desired - Leg spreader for legs longer than 40 cm Planter and Drain Plate Print Details: - Nozzle: 1mm (can also work with 0.8mm) - Vase Mode - Material: PETG - Extrusion Width: 1.2mm - Layer Height: 0.44mm - Bottom Layers: 3 (use 4 if you want to prevent leaking) - Print Speed: 40mm/s For the added files: - Leg Spreader and Dowel Jig: You can use a 0.3mm layer height with 2 perimetes and 5% Infill - 3D printed Legs: 0.3mm layer height with 3 perimeters and 15% infill. Adjust the lenght in your slicer by lowering the model below the platform. How to cut and install the legs: 1.- Mark the legs with your desired lenght 2.- Place the 1 inch dowel in the jig 3.- Align the mark with the top of the jig and make the cut 4.- If the dowel is to tight sand it slightly and if it is too loose you can use hot glue so it doesn´t fall when the planter is moved.