Plant Pot on Stilts

prusaprinters

<p>A plant pot on 3 stilts. The pot itself has a small hole at the bottom end to drain water. The base has a small hole in the middle to catch the water and conduct the water in 3 directions in the pool. 15% infill for the base should be good enough.</p><p>Instead off the printed poles you can use metal also if you have but its not a must have. The poles have a diameter of 6mm and a length of 200mm. Put the seam of the pot behind a stilt so you have a clean surface. Just print walllines 0.2 and no infill for the pot.</p><p>The poles should be printed with 3 walllines and minimum 20% infill.</p><p>Enjoy</p>