Plant Pot Lid

thingiverse

Our cats seem to love digging in our pots. I created this design to solve the problem. This is my first attempt at OpenSCAD, so bear with me. All measurements are given in millimeters. Be sure to pad the pot diameter by about 4mm when printing, as it may shrink slightly or not be perfectly round, and you'll need a few of these designs to fit together properly. To assemble the design, generate half at a time. This will create both the outside and inside clips that hold everything in place, or you can simply use a rubber band like I did on my first print. If you enjoy this design and want to encourage me to continue sharing free 3D printing models, consider sending a tip. Your support means a lot to me. Thanks, James