Plant Parking / Tray

prusaprinters

<h4>The Problem</h4><p>When repotting there is always a point when one need to ask oneself “Where the hell do I put this pot without getting dirt and water everywhere?”. When switching two plants in their pots, where do they go in the meantime? Or when things just do not go as planned and suddenly you have plants in pots without any outer pot available.&nbsp;</p><p>Simply, you have a flower pot spilling dirt and water everywhere and WHERE DO I EFFING PUT IT?!</p><h4>The Solution</h4><p>A simple tray that I call the Plant Parking. &nbsp;Use it in between plantings, to isolate a sad plant, to avoid a mess and make life a little easier. It has ridges to avoid drowning the plants if it's wet, and the edge where the wall meets the bottom is curved to prevent leaks due to layer lines.</p><p>&nbsp;</p><p>Prints without supports, I used PLA and it has worked great so far.&nbsp;</p><p>&nbsp;</p>