PKD-2019 Blade Runner blaster.

thingiverse

I have printed at 0.2 layer height for the most part, however small parts like triggers and switches are typically printed at 0.05 layer height to achieve precise details. Version history: 1.01: Regrettably, I discovered an issue with the clip - the on/off box was too large, causing the switch lever not to protrude far enough. It has been rectified now (only the clip.stl file has been modified). 1.0: The clip has been updated for a more accurate switch box. The text placement on the Steyr frame has also been revised. Old and alternative versions have been moved to a zip file called AlternativeFiles.zip to avoid confusion. 0.94beta: I made some changes to the clipholder to add more clearance to the receiver - it was slightly too tight to fit the wires in-between. 0.93beta: The diameter of the tube has been adjusted to make it more accurate, and the boltfront has been modified so there is no gap when inserted in the frame. A minor error in the Steyr frames has also been fixed - if you have already printed one, it's just a matter of filing a little bit in the notch where the handle (boltmiddle) goes. 0.92beta: The clip has been updated to include on/off lettering, and a new improved Steyr frame (stronger and more accurate) has been added. The right cylinder cover has also been revised for greater accuracy. This is probably the last beta version - if you think I should make any changes, please let me know before this Friday (May 15). 0.91beta: The SteyerSwitchV2.STL model has been added, which is more accurate. Additionally, grips with no pattern and a hollow version of the butt have been included (these were requests from builders). 0.9beta: I added the clip and clipholder. The model is now complete (and therefore in beta)!! I will make some changes over the next couple of weeks - a few inaccuracies will be fixed, and a few structural issues addressed. But it should print fine as it is now! 0.85alpha: Grips and butt have been added. 0.84alpha: The left cylinder cover and "screwdriver" have been added. 0.83alpha: The Right cylinder cover with knobs has been added. 0.82alpha: The bolt for the Steyr frame has been added. 0.811alpha: A resin printer version of the Steyr frame with more accurate markings has been added, along with a minor update to the standard frame (the letters have been made a little deeper so they won't be lost after sanding and filling). 0.81alpha: The Steyr frame, tip, and switch have been added. A small issue with the cylinder and bulletcasing has also been fixed. 0.8alpha: Initial upload containing the Charter Arms receiver, triggers, cylinder, cylinder swing arm, cylinder switch, outer handle, barrel, and bullet.