Pixhawk Safety Switch Mount

thingiverse

This is for installing the Pixhawk arming switch. I built this mount by drilling a hole in the plate it will be attached to so the switch can pass through it completely (about 14mm), then this mounts the switch securely. I designed this to fit on my frame's GPS pedestal holes pre-drilled into my top plate. Hopefully, it will also fit yours; if not, I can resize it for a larger X-configuration. There are three versions available, and I recommend either version v2. Version 1 is the standard mount with a non-flat bottom. I designed this specifically for my ZD850 frame. Version 2 has the same non-flat bottom as Version 1 but has screw holes extended upward to hide the remaining threads on the screws. Version 2 Flat has the same design, hiding the screw threads, but with a flat bottom. This is easier to print and should still do the job effectively.