Pixel Stake for 1/2 inch EMT conduit

thingiverse

I wanted to create a "Peace family" pixel stake that I could mount on top of 1/2 inch EMT conduit. I live in a snowy climate and wanted to mount the pixel stakes about 8-12 inches off the ground to allow room for snow to fall without covering up the pixels. The bottom "friction fits" on the EMT conduit using little "nubs" inside the "cap". This remix makes a few additional changes from the original: I made the holes 42mm (about 1.65 inches), which maximizes the distance between holes while still allowing it to fit sideways on an Ender 3/5 bed (and you can fit 10 at once!). Should still fit on smaller beds diagonally. I also made the stake a bit thinner (6mm instead of 10mm) to save on filament. It still seems plenty sturdy.