Pixel 7a - RE-LOAD -Qi Align helper

thingiverse

Since the Qi Coil of the Pixel 7a is rather small and the Qi-Charging Speed isnt really fast (phone is limited to max 7,5W) the Alignment of the Phone on the QI Charger is critical. If the Phone is slightly Offset, the Charging speed will decrease. So i Designed a Simple Alignment Helper Tool, just Place the Phone with its Top Side to the L shaped Bracket !! Attention: Only Tested with the RE-LOAD Wireless Charging Pad (Art-No.: 3011963 / Item-No.: 75.018.46 / 22CL05) But i think it will work with every Charging Pad, as long as it is 100mm in Diameter and has the Coil in the Center There are two Versions: -Align helper Qi-v2.stl This is the Normal One, just for Aligning. -Align helper Qi-v2-Active.stl Since Cooling the Device while Charging can enable the Device to charge with higher Ampere for longer, i decided to adapt the Modular Fanholder from my other Charging Cooler found here: https://www.thingiverse.com/thing:6058080 If you decide to print the Cooling Version, you´ll need supports for the Press-Fit connector, since it will Overhang. i Printed them Upside Down, worked flawless. I taped the Charger and the Holder to the Table with Double-Sided Tape