Pixel 4a Case Hex

prusaprinters

EDIT/WARNING: This must be printed in flexible filament such as TPU. It will not fit with PLA, PETG, etc. Google Pixel 4a (not 5g) case , based on the design by fiunkel. Changed the following:Removed the headphone jack (I never use it, just keep it from collecting dust this way)Made the side buttons outdented instead of holes. Much easier to find/press this way in my opinionAdded a hole on the top of the phone for the top micEnclosed the bottom where the usb port is and left 3 holes for the port and speakersCut out the back, leaving most of it uncovered to glue a popsocket or similar (or just enjoy the phone design underneath)Changed the back design to hex instead of the previous patternPrint SettingsPrinter:Sunlu S8Rafts: NoSupports:Doesn't MatterResolution: 0.16Infill:Doesn't matterFilament:Unsure TPUBlue Notes: I used tree supports in Cura just to make the usb port and speakers a little easier. You could get away with not using them depending on how good/bad the bridging is on your printer.  Category: Mobile Phone