Piranha Adjustable Length Scooter Stand

prusaprinters

<p>I made a stand for the Dive-Xtras Piranha to use when I am traveling in my car. I wanted a model that I can use that could be adjusted to work when I am using it as a P1, or P2 mode, or when I add my Survey Tube (could get long as P3). So I wanted a design that can be adjusted in length. You will need to print 2 of these stand, insert 2 x 1" (diameter) PVC tube and slide the stand to adjust the length depending on the configuration. The size of the hole is about 1.25" +/- (I used hole size 33.9mm which was about the width of 1" PVC pipe exterior measured with little buffer so I can adjust the pipe easier. The center hole is optional and its there for additional stability if needed…&nbsp;</p><p>For the pipe length, I used 18" because I had a 36" pipe laying around and I split it into two, you can cut to fit and even put an end-cap if you want to make it look more finished. &nbsp;If you plan to use it only for P1 and P2, you can reduce this length to 14" or so and 10" if you only want to use it for P1.</p><p>If you want to expose the honeycomb pattern, set the bottom and top layer to 0, I have posted the 3mf file with the settings and code, but you may want to export your own code using the stl since I used my Mk3S+ with MMU2 in single print color mode.&nbsp;</p><p>Printed using PETG, 10% Honeycomb Infill, printed in DRAFT, No Bottom and Top Layer. Set Fill angle to 0', Vertical layer set to 3.</p><p>Originally I printed using 15% infill but I found the 10% strong enough and also looked better with larger honeycombs and rotating the fill to 0' aligned the fills to my print much nicer.</p><p>If you don't want see through honeycomb look, you can use the stl file and export normally and use different fill pattern you prefer. I used the honeycomb for strength but also I think it looks pretty cool.</p><p>You can shave about 1:50 min from your print if you use rectilinear fill instead of honeycomb.</p><p>&nbsp;</p><p>Also take a look at my PTB Seal Protector I made that would compliment this print, you can use it to protect the PTB or your Survey Tube if not installed on your Scooter.</p><p><a href="https://www.printables.com/model/173275-dive-xtras-piranha-ptb-seal-protector-v1/files">https://www.printables.com/model/173275-dive-xtras-piranha-ptb-seal-protector-v1/files</a></p><p>I prefer to use the cover version for the PTB and the ring version for the Survey Tube.</p><p>&nbsp;</p><p>I appreciate your feedback and comments on this print.</p><p>&nbsp;</p><p>&nbsp;</p><p>Designed using Tinkercad.</p>