PIR sensor faceplate - Bracket for PIR sensor with wire control.

myminifactory

I just started using PIR sensors with my Raspberry Pi to automate some lights around the house! After searching for some suitable brackets, I found that none of them would work for my specific situation. These brackets are straightforward and easy to use - no extra fitting is required for the sensor unless you specifically need to secure it in place. In my case, the push fit was sufficient to keep the sensor stable. One bracket has a right-angle design and the other is slightly angled, allowing me to point the sensor down if I mount it high up on a wall. There's also a 5mm cable guide at the back of each bracket for added tidiness!