Pipe Clamp Phone Holder

pinshape

I designed this phone holder so I could mount it securely to my monitor arm. The diameter of the pipe that the holder attaches to is 32mm. For detailed dimensions of the phone holder itself, check out the technical drawing with key measurements. The phone holder is printed in four parts, but you'll need some extra hardware to assemble it. There's an image showing exactly what hardware you'll need. If you want to use the same hardware I used, you can order nuts and bolts from this affiliate link: mounting hardware You may want to examine the orientation of the midpiece carefully because excessive support material can cause a rough print finish. The same issue applies to the phone holder part itself. Adding too much support material here can cause the side flaps holding the phone in place to break off when you try to remove the support material. If you'd like to support my free designs, consider using my AliExpress Affiliate Link when making a purchase from AliExpress. It won't cost you anything extra, but it will help me out significantly.