Pipboy 2000 Mk4 v1 (psuedo-scuffed)

thingiverse

This is the pipboy I wore at PAX east 2022. Some additional holes have not been fully tested on the datatapeholder as I drilled them in when assembling. The selection knob is a loose fit and needs superglue so it doesnt fall off. Inside of the radbox (that connects with the back.stl pieces) needs to be carved somewhat to allow better fitment with the USB cables. The radbox_bottom_left wall could be thinner where the volume not goes through so that it may have more threads to catch. With how back.stl lines up with the usb power cable attached screenboltcover_2.stl does not align properly. Speaker gate falls off when taking off supports. Total est print time: 139+ hours Total est print cost: 1 kg + failed prints + fitment checks Parts list: Raspberry Pi 3B+ Find local retailer ~$35 Screen Elecrow 5 inch - $45.99 https://www.amazon.com/gp/product/B013JECYF2 Arduino Pro Micro (equivalent) - $22.99 https://www.microcenter.com/product/621833/sparkfun-electronics-qwiic-pro-micro-usb-c-(atmega32u4) Speaker kit - $11.99 https://www.amazon.com/gp/product/B07CRVRG83/ Red Button $.22*7=$1.54 https://www.taydaelectronics.com/pb-11d02-push-button-panel-mount-spst-no-pb-11d02-th1r00.html Top buttons - $.94*4=3.76 https://www.digikey.com/en/products/detail/e-switch/TL1240NQ1JBLK/1805479 Selector knob - $9.99 https://www.amazon.com/gp/product/B07F26CT6B/ Right angle USB adapter - $6.99 https://www.amazon.com/gp/product/B0793NQRYZ/ Mini PCB board - $9.99 amazon.com/gp/product/B081MSKJJX/ Battery pack (lasted ~4-5 hrs/pack) $17.95 https://www.amazon.com/gp/product/B08XBN7HRT/ 90 degree usb-micro b to USBA cable - $6.00 https://www.amazon.com/gp/product/B01787LBF0/ 90 degree USB-A to usbC connector - $9.98 https://www.amazon.com/gp/product/B07WRPLSLB/ Flexible Jumper wires $5.49 https://www.amazon.com/gp/product/B077NH83CJ/ Spare ethernet cable - Sacrificial USB cable (needs dedicated wires for 5V and GND for speaker)