Pip-Boy adjusters

thingiverse

Did you print a copy of the Pip-Boy for Iphone 5 by b761d67 from http://www.thingiverse.com/thing:889893 or its variation, only to find it won't fit your arm? Just download this model, print it out, and it'll fit even the largest arms with ease! Print Settings: Rafts are completely unnecessary in this case. No additional supports are required for proper structure. Resolution settings can be customized; refer to the detailed notes below. Infill density may need adjusting as well - check the supplementary information provided. Notes: This model printed flawlessly at a 2mm layer height, standard settings applied, however please adjust print settings according to your specific Pip-Boy configuration requirements. Post-Printing: Once printed, carefully insert the respective wedges between the two halves of the cuff. You'll require longer screws for assembly. It's also possible to stack additional copies of the wedge to enlarge the cuff further if necessary. Remember, the 'Outer' file goes on the 'Screen side', positioned towards the outside of your forearm when worn as described - i.e., with Pip-Boy screen orientation simulating actual left-hand usage. Always install the narrow ends of the wedges towards your wrist for proper alignment.