Pioneer Car Audio Radio Knob

thingiverse

Replacing a knob on your Pioneer car stereo is a relatively simple process that requires some basic tools and mechanical skills. Start by locating the screw holding the existing knob in place. Use a Phillips-head screwdriver to remove this screw, taking care not to strip it. Next, pull out the old knob and inspect its base for any remaining screws or clips. If there are any, use your screwdriver to release them. Once you've removed all the hardware holding the knob in place, gently pry the old knob off the stereo's control panel. With the old knob removed, take a close look at the area where it was attached. You'll likely see a small metal clip or retainer that held the knob in place. Use your screwdriver to carefully remove this clip, taking care not to damage the surrounding plastic. Now, take your new Pioneer car stereo knob and align its base with the metal clip you just removed. Gently push the new knob onto the control panel until it clicks into place. Make sure it's securely seated by giving it a gentle tug. Finally, replace the screw that holds the knob in place, tightening it firmly to secure the new knob. Test your new knob by turning it through its full range of motion to ensure it's working properly.