Pinwheel / Windmill - 6 wings (Garden / Toy)

prusaprinters

<p>This is a little windmill that adds a little color sport into your e.g. garden. It's mainly a 200mm x 200mm x 0.4mm flat sheet of plastic with some mounts for the bent wings and a 10mm stick.</p> <p>If you like this thing, you might want to print those, too:</p> <p>Windmill (Garden / Toy): <a href="https://www.thingiverse.com/thing:3664786">https://www.thingiverse.com/thing:3664786</a></p> <p>Butterfly - Wiggly colorful blobs for the garden or flowerpot: <a href="https://www.thingiverse.com/thing:3668684">https://www.thingiverse.com/thing:3668684</a></p> <p>Butterfly - Wiggly colorful blobs for the garden or flowerpot: <a href="https://www.thingiverse.com/thing:3666452">https://www.thingiverse.com/thing:3666452</a></p> <h3>Print instructions</h3><h3>Category: Outdoor &amp; Garden Print Settings</h3> <p><strong>Printer Brand:</strong> Prusa</p> <p><strong>Printer:</strong> <a href="http://amzn.to/2rqZ6Uo">i3 MK3</a></p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> 0.2mm (that's important)</p> <p><strong>Infill:</strong> 10% (doesn't matter)</p> <p><strong>Filament:</strong> Das Filament PETG Melonengelb (Melon Yellow) / Weiß (White)<br/> <strong>Notes:</strong></p> <p>I've added 2 versions of the butterfly:</p> <p>The parts starting with MMU are designed (but not tested) for multi color / multi material printing.</p> <p>The other parts are design for single extrusion printers (like the one I'm using). I've used this service <a href="https://blog.prusaprinters.org/color-print/">https://blog.prusaprinters.org/color-print/</a> to insert a filament change command at layer height 0.6mm into a gcode file rendered by Slic3r / PrusaSlicer. Might work with other slicers, too.</p> <p>If no MMU part is available but a standard one, just print the standard one.</p> <p>You've to print Windmill_8_Wings-Cap-Body1.stl and Windmill_8_Wings-Wings-Body.stl twice.</p> <h3> Post-Printing</h3> <p>Grep both Windmill_8_Wings-Wings-Body.stl parts**</p> <p>Lay them over each other and make sure that the wings are alternately up and down.**</p> <p>Glue the ends of the wing with a half twist to the center.**</p> <p>If all wings are glued to the center, glue the Windmill_8_Wings-WingCover-Body1.stl to the center**</p> <p>Stack the parts like this. The only glued parts are the very left (cap) and the 2nd from the right (WingCover)**</p>