pinion 4

thingiverse

Instructions Using the following settings: nidler is set to 2 idler height is set at 1.5 millimeters only one nut will be used the distance between nuts on the shaft is 1.2 millimeters an extra width of 0.2 millimeter has been added to the teeth the top of the pulley block is six millimeters high the additional tooth depth is zero millimeters m3 nut flats are five point seven millimeters deep the m3 nut is two point seven millimeters deep m3 diameter is three point two millimeters only one retainer is used, which has a height of 2 millimeters there is one hexagon hole in the center for the nut with a diameter of one millimeter pulley block outer diameter is twenty millimeters teeth are twenty-five in number profile width is twelve millimeters retainer ring top height is one point five millimeters top thickness of pulley block is zero millimeters nut hole angle is ninety degrees, same as shaft Created with Thingiverse Customizer