Pinda/Minda Height Adjustment Block - 1mm

prusaprinters

<p>Just a simple block that allows the quick adjustment of a Pinda/Minda sensor to 1mm from nozzle tip. No zip tie needed and you don't need to run the Z all the way to the bed.</p><p>Place vertically on heat bed and run Z down to where the nozzle touches the ‘nozzle’ side of the block. Swing the block around to where the sensor side is under the Pinda/Minda and then adjust the sensor until it is touching that side. This will set your sensor approx 1mm from the tip of the nozzle. Make sure your nozzle is clean before using.</p>