Pinch Camera Mounts

thingiverse

A pair of rugged camera mounts for the Tinywhoop FX965TW Pinch camera/vtx is now available. One mount stands at a standard height, while the other is designed to be low-profile. Both offer 20 degrees of upward tilt and securely hold that tiny camera in place. If you use the recommended filament type and print settings, this mount will weigh significantly more than Tinywhoop's own mount once double-sided tape is applied to secure the vtx in position. I also advise using a small amount of double-sided tape on the bottom of the low-profile mount; even a moderate impact can push the camera board below the mount and onto your flight controller if that lower brace fails. The standard height mount will fit not only my Swoop and Sloop canopies but also the legacy Tinywhoop Razor and Stingray canopies. However, I do not have access to newer versions of Tinywhoop's canopies for testing purposes. On the other hand, the low-profile version is designed to fit my Stoop, Swoop, and Sloop canopies, with a particular emphasis on the Stoop design.