Pinch camera mount 30-35 deg

thingiverse

This camera mount for the Tiny Whoop Pinch was designed based on suggestion and input from Pawel Stefanski. The weight is ~0,8g Versions: Pinch_30deg_mount_rev11_with_corners.STL The corners are best for soft materials (TPU etc.), as the camera can be difficult to insert. Pinch_30deg_mount_rev14_beta_nbd.STL Version with cutout for camera connector on Betafpv and NBD fc's - with input from Drimal Peter. Pinch_30deg_mount_rev12_reduced_corners.STL Reduced corners which should provide easier camera insertion. Pinch_35deg_mount_rev14_with_corners.STL The corners are best for soft materials (TPU etc.), as the camera can be difficult to insert. Pinch_35deg_mount_rev13_reduced_corners.STL Reduced corners which should provide easier camera insertion. Tested materials so far: PA6+CF Might require trimming of the mount with a knife to make camera insertion possible/easy. A softer material is recommended. (100 infill, 15% support with 0,3 z gap) Taulman PCTPE (~ same parameters) Difficult to insert the cam with full corners. TPU Shore 55D (~ Same parameters) Other tough materials might be suitable as well. Avoid brittle materials. The mount is designed for fairly flexible materials as the Taulmann PCTPE. In hard materials, some tweaking might be required to insert the camera.