Pinball Plunger Puck

thingiverse

Does your plunger sucks? My brand new Avengers Infinity Quest cannot make a full plunge more than 20% of the time - meaning that when I pull the shooter rod back fully and release, it won't always make it up the ramp in the back of the machine. You can add a stronger spring, which could add wear and tear to your machine and may not exactly fix the problem. The plunger puck fixes the problem which is that the plunger is just a hair too short to make contact with the ball at the right plunger velocity. Included in this thing are two sizes of pucks - 1.5mm and 3mm. To install: 1. Remove your plunger rubber without messing it up (don't blame me if you rip it!) 2. Hold the plunger puck on the end of your plunger metal 3. Slide the plunger rubber back over the plunger until it fully seats. The plunger puck should be seated flat in the end of the rubber. If it's twisted you may need to remove it and start over. This can be tricky - you may need some small needle nosed pliers and a flat screwdriver.