Pinball Plunger Low Profile / Baseplate V8

thingiverse

Note: Modified version for backplate with launchball button support, design was not sufficient to support plunger impact, so I modified the backplate and recommend printing it vertically so layers are in correct orientation for impact resistance. Remix of pinball plunger low profile header from @BudDevil. On my plunger, the circlips retaining the spring at end of shaft do not fit. So I modified the piece to allow passage of this circlip. I also added a backplate to properly close the support and protect the potentiometer. Two versions: - Normal - With launchball button support It's a service button type with 7mm drilling hole. This is the product type: https://www.smallcab.net/service-button-red-p-885.html Edit of August 15, 2019: Modification in V5 of backplate with launchball support for addition of a drilling to allow passage of cable from launchball button directly through backplate. Oddly, I did not think of this until the support was in hand and the button was in place. Edit December 26, 2019: Modification of bottom plates for consolidation. Added reinforcement on ends.