Pin Vice 20 piece bit holder

thingiverse

I recently purchased a new Pin Vice and found the tool and bits to be excellent, but the box they came in was subpar (I disliked having to pick up each bit individually whenever I needed to change it) so I created a custom holder using Fusion 360. The design is optimized for resin printing with precise tolerances, however there's no reason why it can't be printed with FDM at high resolution. Two versions are included: v1: This initial version features 1.7mm diameter holes (be aware that if you print this you may need to drill out the holes slightly for larger bits as they're a bit tight), and the lid simply rests on the edge rather than securely fastening. v2: This version has larger holes approximately 1.9mm in diameter, a ridge along the base's edge allowing the lid to fit securely, and a recess to store the Pin Vice itself (the lid features a hole for it to pass through). The v2 lid also fits snugly over the ridge if you don't use the recess to store the vice, providing a closed box.