Pin Vice 20-Bit holder

myminifactory

I recently purchased a new Pin Vice and while I'm pleased with the tool and its accessories, the box they came in left much to be desired (I wasn't looking forward to playing 20-bit-picker-up every time I needed to swap out a bit). So, I decided to design a new holder using Fusion 360. It was designed specifically for resin printing, with very tight tolerances, but there's no reason it can't be printed with FDM if the resolution is high enough. Two versions are included: v1: This was the initial version, featuring 1.7mm diameter holes (keep in mind that if you print this version, you might need to drill out the holes slightly for the larger bits, as they fit a bit too snugly). The lid simply rests on the lip without securing it. v2: This upgraded version boasts larger holes (approximately 1.9mm) and an edge ridge on the base that allows the lid to fit securely. It also features a recess to store the Pin Vice itself (the lid has a hole where the vice can be placed). If you don't want to use the recess, the v1 lid will still fit snugly over the ridge, giving you a closed box.