Pimoroni Plasma 2040 Case w/Buttons

thingiverse

This is a snap together case for the Pimoroni Plasma 2040 LED controller. There is a hood over the USB connector and opening for the LED connector wires. This case has a hole for a light pipe to bring the on-board LED out of the case. The light pipe hole is designed for P/N 492-1154-ND from Digi-Key, a PLP2-500 12.7mm light pipe. The case also has holes for four buttons to provide access to the on-board switches. The Plasma snaps onto the posts in the base. It may be a tight fit initially, but the board stays in place. The base then fits into the top. When using the buttons, it is easiest to hold the top upside down and install the buttons. Then, invert the base with the controller board mounted and snap into the top. This keeps the buttons from falling out until the case is together.