Pimoroni Inky Impression Case

prusaprinters

<p>A wall-mounting and desk-stand case for the Pimoroni Inky Impression 7-colour e-ink display and Raspberry Pi Zero</p> <h3>Print instructions</h3><p>This is a wall-mounting and desk-stand case for the <a href="https://shop.pimoroni.com/products/inky-impression">Pimoroni Inky Impression</a> 7-colour e-ink display. I wanted to make a simple protective case for the display and a Raspberry Pi Zero W which had the following features:</p> <ul> <li>A clean front with no visible fixings and a symmetrical border around the image area</li> <li>No pressure applied to the fragile glass screen of the Inky Impression</li> <li>Access to the 4 buttons on the Inky Impression board</li> <li>Access to the breakout connector on the Inky Impression board</li> <li>Simple wall-mounting</li> <li>Optional desk stand</li> </ul><h3>Printing</h3><p>Print the following parts:</p> <ul> <li>1 x inky-impression-case-frame.stl</li> <li>1 x inky-impression-case-backplane.stl</li> <li>4 x inky-impression-case-button.stl</li> </ul><p>And, depending on whether or not you are using threaded inserts, either:</p> <ul> <li>1 x inky-impression-case-rearpanel.stl (with inserts)</li> </ul> or: <ul> <li>1 x inky-impression-case-rearpanel-no-inserts.stl (without inserts)</li> </ul><p>There is also an optional desk stand that clips into the keyholes on the rear panel:</p> <ul> <li>[OPTIONAL: 1 x inky-impression-case-stand.stl]</li> </ul><p>The design is optimised for a 0.4mm nozzle and 0.2mm layer height with 20% infill. Using a concentric pattern on the bottom layer gives a nice finish to the frame.</p> <p>You will also need:</p> <ul> <li>4 x M2.5 bolts, 6mm long (you can use the ones supplied with the Inky Impression)</li> <li>4 x M2.5 countersunk bolts, 6mm long</li> <li>[OPTIONAL: 4 x M2.5 threaded inserts - brass heat-set type, external diameter 3.5mm, length 4-6mm]</li> </ul><h3>Instructions</h3><p>For full assembly instructions, go to:</p> <p><a href="https://github.com/scripsi/inky-impression-case">https://github.com/scripsi/inky-impression-case</a></p>