Pill Box with Magnets - Enlarged

thingiverse

I printed KGeorge's original pill box and got it to work, but I thought it could use a few enhancements. For starters, I doubled its width. With the original, I could only fit three tablets. Since I was used to using an old Anacin tin, I needed more storage. Next, I resized both pieces to allow for clearances where the two halves meshed. In the original, I found that I had to size the bottom half up by 102% to let the top slide on smoothly. Third, I resized the magnet holes and added necessary clearances, but this time I made them fit the 4mm x 2mm magnets in stock. Finally, and this only applies to me, I cut two recesses into the bottom to hold two additional magnets. This way, my pill box can stick to a front pocket wallet with magnetic closure like my old Anacin tin did. Most people will leave these out and it won't affect anything. Due to either a Thingiverse bug or (more likely) shadowbanning, my models no longer show up under the Newest listings. If you want to see more of my models, please follow me. Another Sketchup Model - Debunking the Myth that Sketchup is Useless in 3D Printing