Picture Hanger (Sawtooth)

thingiverse

I'm a big fan of custom framing for my printed photos, but I've often found that the frames lack a secure mounting point. That's why I was excited to try out this 3D printed attachment, which sticks firmly to the back of the frame. For lighter frames, I swear by high-strength 3M mounting tape (the 1-inch wide Scotch Extreme Mounting Tape is my go-to). But for heavier frames, I recommend using a strong adhesive like cyanoacrylate or hot melt glue - it's my top pick! When it comes to hanging the frame on the wall, I always use WallDriller drywall anchors. Truthfully, just about anything will work, but these have been my reliable choice. Printing this part was a breeze, using 50% fill and layer settings of .15 to .2 mm with support enabled. And that's it - enjoy!