Pickup-Select Switch Knob

Pickup-Select Switch Knob

prusaprinters

A replacement knob for an electric guitar pickup select switch. This was for my strat copy, but I suspect it will work for a variety of pickups switches.It prints very quickly and seemed to work well, once I got the hole sizing right. Hope it works for you. Good news is that at less than a gram and printing very quickly, there is not much time to be wasted in finding out.The switch I used it on has approx a 1.3mm x 7mm rectangular cross section.Possibly the smallest thing I've designed and printed! :) Notes:Doesn't need supports as inner ceiling is so small.Depending on your printer you may need to clean it up a bit with some sandpaper or a knife. Check inside the hole and clean that with a tiny file or tweezers if necessary.If it's very snug on your switch, try warming up the knob with a heat gun or hairdryer (just a bit!) and push it on while it's slightly rubbery. (may need a glove to avoid burning fingers).If it's very loose, try a bit of glue.  If you mess it up, don't worry it uses about a penny's worth of filament and prints in a few minutes. I needed neither - just a bit of gentle force and it was on without problems. Careful not to push too hard, as you can break your switch, and you don't want that.Design Date: Oct 2017Category: Music

Download Model from prusaprinters

With this file you will be able to print Pickup-Select Switch Knob with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Pickup-Select Switch Knob.