Picatinny 5 Slot Rail Riser (1 Inch)

thingiverse

Picatinny 5 slot 1-inch rail riser. Used for mounting a small red dot optic or similar device. PRINT STANDING ON END OR IT WILL NOT WITHSTAND STRESS IN THE DIRECTION OF MOST STRENGTH. Supports #6 - 32 1" hardware. The nut and bolt holes (and length) are designed to accommodate. To install this item, simply slide it onto your rail if you have a Picatinny rail with a floating barrel. If there's no obstruction, it will fit right into place. If not, you'll need to snap it in. I've used PLA/wood material and found it strong enough to withstand the stretching of the rail. To snap on, place one side of the riser onto the accepting rail and pull it over until it expands enough to snap into place. To remove, use a screwdriver carefully so as not to scratch the accepting rail, and lift one edge of the riser off the rail. With a little pressure, it should pop right off. Good luck!