PiCam GoPro Mount - OpenSCAD

prusaprinters

<p>GoPro mount combined with Raspberry Pi Cam mount to allow for a versatile selection of mounts and such. Dimensions taken from the following two links:</p><ul><li><a href="https://www.raspberrypi.org/documentation/hardware/camera/">Specs page</a></li><li><a href="https://www.raspberrypi.org/documentation/hardware/camera/mechanical/rpi_MECH_Camera2_2p1.pdf">Mechanical Drawing</a></li></ul><p>Re-created the relevant part of the design in OpenSCAD, using the 2-flap version of <a href="https://www.printables.com/model/320972-basic-gopro-mount-openscad">an earlier GoPro mount design</a> that I finally got around to isolating and taking measurements from the official PiCam mechanical drawing. Should make mounting my <a href="https://github.com/ccrisan/motioneyeos/wiki">MotionEyeOS</a> setup a snap!</p><h3>Recommendations</h3><ul><li>Print with high infill for security of the GoPro mount</li><li>M2 hardware</li><li>Use eight nuts rather than four, with one set serving as standoffs to prevent the plastic from crushing the components on the backside</li></ul><h3>Changelog</h3><p><strong>2018-09-12</strong></p><ul><li>Initial Upload</li></ul><p><strong>2018-09-21</strong></p><ul><li>Print and pic update</li></ul><p><strong>2018-10-01</strong></p><ul><li>New pic</li><li>Adjusted recommendations to include standoff info</li><li>Removed "unverified" notice leftover from 2018-09-21 update</li></ul><p>Category: Camera</p>