PI4 case with fab

thingiverse

link to original post: https://www.printables.com/model/21430-pi4-case-fancover-wcamera-slot Description Added screwless-jack.stl file! New Dome with larger Camera Slot New printing supports Also includes "Screwless Jack stand"... for those who don't want a fan, and don't have screws... keeps the Pi in place without screws. NB Use Dupont connector for GPIO connections. Case for Noctua 5V 40x10mm 4 pin Fan... Compatable with "Raspberry Pi 4 B Case (SnapTop)" and FlatTop Solid Case CPU stays very Cool. 36C during stress test (100% Fan) Bracket frame mounts on 10 mm standoffs. CPU takes 9mm tall (9.4mm) Heatsink... Fan fits into fan frame snugly, no screws required. M2.5 screws needed on bottom of case to secure Pi4B board to standoffs. Case also fits into Bracket For Case (Raspberry Pi 3B and 4B) Cases FlatTop, etc Case cover snaps on, also fits other Raspberry Pi 4B case... (SnapTop). See Black and white version render. Fan connects to GPIO pins and can be controlled via PWM. Possible to connect to 3.5V pin and keep fan quiet, performs well. https://electronics.stackexchange.com/questions/446128/5v-4-pin-noctua-a4x10-on-raspberry-pi Also look here... https://blog.pimoroni.com/raspberry-pi-4-thermals-and-fan-shim/ Noctua Fan... NOCTUA NF-A4x10 5V PWM, Premium Quiet Fan with USB Power Adaptor Cable, 4-Pin, 5V Version (40x10mm, Brown) Please review Comments Sections… Great Questions. Camera Cable Mounting There are 2 slots for ribbon cables, the rear facing slot (on the Dome cover) works well for the camera. With the fan and fan stand removed, insert the ribbon cable into the CSI mount for the camera, insert the fan stand and then fan. The ribbon cable will need to slide through the rear slot on the cover, mount the fan cables to the gpio pins and place the cover on. The ribbon cable will make an S shape in order to align itself 90 degrees to the io side of the pi (slight angle). The camera can now be attached to the ribbon cable, and will likely need a mount in order to direct to the extruder. Print instructions Added PLA, PETG gcode and PSlicer 3mf 3MF has variable layer height and support enforcer... Prints in ABS... Supports are required and much time and effort was put into finding the correct supports that could be easily removed and develop a clean part... Use a thin Shim printed from ABS about the size of a flat razer to detach supports...or use a flat razer... The gcode file for the top cover has this support and it can be removed by fitting a flat razor or thin piece of metal and prying up on the sides... the entire support can be removed in a single piece, requiring very little cleanup. The Bottom Case has prefabbed supports which pop out.