Pi1541-II Case

thingiverse

This is a Pi1541-II Case for the Backoffice Show PCB created by Stephen White for the Pi1541 software.\r\n\r\nThe design is still under development and various adjustments are needed to finalize it.\r\n\r\nThree-millimeter self-tapping screws are required.\r\n\r\n__v1.1__\r\nUpdate to the lower sections of the case, they need to be taller and a pillar was slightly misplaced for the HDMI port access.\r\n\r\n* case-bottom.stl\r\n* case-middle.stl\r\n* full-case-bottom.stl\r\n* full-case-bottom-with-oled-screw.stl\r\n\r\n\r\n__v1.2__\r\nUpdate to full case top sections, my OLED screen and board didn't fit quite right.\r\n\r\n* full-case-top-face-large-oled.stl\r\n* full-case-top-face-small-oled.stl\r\n\r\n\r\n__v1.3__\r\nAdjustment for tolerances on OLED screens.\r\n\r\n* full-case-top-face-large-oled.stl\r\n* full-case-top-face-small-oled.stl\r\n* case-face-large-oled.stl\r\n* case-face-small-oled.stl\r\n\r\n__v1.4__\r\nEasier to print just the top with front attached, removed separate parts.\r\nMoved front posts back for more room.\r\n\r\n__v1.4.1__\r\nMoved the Pi closer to the edge, removed large oled version because it wasn't correct and needs a redesign.\r\nMaybe screen on one side, buttons on the other.\r\nAlso attached is the sketch up file (with current large oled), this file is a bit messy and I think for v1.5 or v2.0 I may start again.\r\n\r\n__v1.5.1__\r\nCompletely redesigned the case.\r\n\r\nThe pi1541-front.stl only needs support, others do not.\r\n\r\nThe old V1.4.1 is still available in zip.\r\n\r\nM2 screws are used to join Mid and Bottom together.\r\n\r\nM3 screws are used to join Top to the base.\r\n\r\nLinks:\r\nhttps://backofficeshow.com/blog/2018/7/21/behold-the-commodore-1541-disk-emulator-hat\r\nhttps://cbm-pi1541.firebaseapp.com