Pi Zero Test-bench case

prusaprinters

<p>This is an open 'case,' more like a test-bench, for the Raspberry Pi Zero, Zero 2, Banana Pi M2 Zero, and others of the same form factor. This is for those who tend to tinker with their RPis more than set them up for permanent use. Easy access if you use the GPIO pins or if you need to get to the SD card frequently, like I do, without worrying what surface the pi board is sitting on.</p><p>This is the start of what will be a slide-together case for the ‘zero’ form factor, but for now it provides an easy print to test with or to put a pi zero on to mess with without printing a full case.</p><p>I printed it using PETG at .15mm layer height with a .25mm nozzle. I bet it will work just fine with a .4mm nozzle if you slice it correctly. Thankfully it doesn't use a lot of filament.</p><p>Print flat. I did &lt;20% infill and it worked great.</p>