Pi Zero Camera Case

thingiverse

I created a Pi Zero case several months ago, but I wanted to design a new one that could also accommodate a camera module. So I dissected my original case and uploaded the parts separately so I could mix and match them to create different cases. This was my first attempt at doing this. The case works with a short camera cable. Four washers fit over the pins where the Pi is attached, holding it in place when glued down. Another piece fits onto the pins that hold the camera card, securing it once the washers are held down. The top and bottom snap together after that. The stand can be used to hold the case upright. It does cover the mini HDMI port, but this shouldn't be a concern if you're setting up a motion sensor camera of some kind.