Pi Zero 2 Mount for Prusa Mini Base

prusaprinters

<p>Just a case/mount solution to mount Raspberry Pi Zero 2 to the excellent Prusa Mini Base mod by David Warboss:</p><p>https://www.prusaprinters.org/prints/63483-prusa-mini-base</p><p>It uses the existing holes in the Mini Base rear right leg, so no modification to the base is necessary, ideal for octopi.</p><p>Requires 4 x M2.5 x 6mm screws to secure the top and bottom pieces, I've added 4 M2.5 nuts at the rear, but they're not critical, just dont over tighten.&nbsp;</p><p>Requires 2 x M3 screws to mount to Prusa Mini Base rear right leg, I used M3 x 20 as that's what is recommended to mount the filament sensor to the right front leg to the Mini Base.</p><p>&nbsp;</p><p>Printed in PLA @ 0.15 layer height, but should work fine with most filaments and layer heights.</p><p>&nbsp;</p><p>This is the original case:</p><p><a href="https://www.prusaprinters.org/prints/84138-slim-raspberry-pi-zero-2-w-case">https://www.prusaprinters.org/prints/84138-slim-raspberry-pi-zero-2-w-case</a></p><p>I've just made the bottom thicker for greater rigidity as the original bottom was very thin, and I've added screw holes as the existing model didn't seem very secure.</p>