Pi KVM - zero 2 case

thingiverse

I recently came across the project http://pikvm.org, something i have been thinking about designing for ages, but this is a lot better than i could have come up with. As i am lucky enough to have a couple of Pi Zero 2's doing nothing I decided to dedicate one to this project. The only thing i found annoying was there cases available for it. THe one they point to on the website is good, but with most things uses a completely different component than i had ( HDMI to CSI module ) I have used - Pi Zero 2 - Pi Zero "Stub" Camera Cable - Geekworm Raspberry Pi Hdmi to CSI-2 Module X630 I've got 2 different versions of the enclosure - pins to slide the pi zero and HDMI module onto - holes for 2mm screws so you can screw the modules down I've also created 3 different lids - Standard lid - Lid with space for you to use the header pins - Lid with space for the .91" oled display I need to figure out a better way to print the lid, it has lost detail as i printed it face down on my print bed :( Note : the OLED display does not work out of the box, there are a couple of modifications to the image you need to make in order for it to work. You need to have dtparam=i2c_arm=on in the /boot/config.txt (remember you need to use the rw command to be able to edit files).You also need to add i2c-dev to a file in /etc/modules-load.d/i2c.conf (the filename isn't really important).