Pi Case for Neptune with Camera Module V3

thingiverse

This is raspberry case with adjustable camera mount (on a pole). The case was designed to attach to ELEGOO Neptune 3 Pro rails (might be okey for other models having rails on the sides). It does not require disassembly of the printer as it snaps snag using hangers. The pole fits very snuggly, you can use file to smooth hole on the case to help adjust it. Screws for the case are typical M3 16mm (3x). The PinLock should fit snuggly as well, adjust printer settings if it is too tight or use file as well. Print orientation (if support is mentioned use TREE support!) - Pole: print 0.2 upside down on the plate (DO NOT PRINT ON THE SIDE!). No suport, no brim. Use 4 or 5 walls to make pole stronger. - CamLid: print 0.2 stand straight, enable tree support for a top bar, no brim - CamCase: print 0.2 stand straight, enable tree support, no brim - PinLock: print 0.15 upside down (on the head), no support, no brim - Top of the case: print 0.2 flat side, use brim to prevent wrapping of the case, no support - Bottom of the case: print 0.2 flat side, use brim as well Good luck and have fun.