Pi camera servo arm for octoprint

prusaprinters

Notice: it's not only for the ender 3 v2 Model descriptions:arm rail mount for a aluminum extrusion (tested on ender 3 v2 extrusion) this one the just tall enough to peak over the ender 3 v2 bed height, this is around 10 cm and 12 cm including the camera hight. the rail is from @ryanba “MODEL LINK”smaller rail mount (tested on ender 3 v2 extrusion) the rail is from @ryanba “MODEL LINK”arm mount for on QR code, so it moves with the Z arm. (double sided tape is recommended) remixed from @3ddruckmarc “MODEL LINK”mount made for the QR Ball joint Arm (I recommend not using joint in-between)the mount point for model 5, this model is designed by @Anders “MODEL LINK”, which is a remix from @3ddruckmarc “MODEL LINK” Credit for all the models used in the renders:picture 1, 2, 5, 6, 7 and 8: ender 3 v2 model used is from: @pakkko_354438 “MODEL LINK”Servo reference model used is from: @demetrius_393003 “MODEL LINK”Servo Arm/Horn used is from: @Cohenco “MODEL LINK”Ball joint QR mount used is from @Anders “MODEL LINK” that is a remix the qr cover of @3ddruckmarc “MODEL LINK"the models for the arm joints used are all from @Erer “MODEL LINK”  I use:a Modular Snap Together Raspberry Pi @Sneaks with a Ender 3 V2 Mounts rail @ryanba, with the model 1 Arm rail mount for a aluminum extrusion. and I use a raspberry pi with octoprint. And for the servos I use the Micro servo 3.9g. with the Easy servos plugin on octoprint. And on the pi i connecter the gpio 22 for the x and 27 for the y IMPORTANT for octoprintYou can use a octoprint plugin to control the servos. the plugin called easy servos made by mledan, iFrostizz and jneilliii.In the image below, you can see the controls and my settings.how to set-up is described on the Plugin Repo “LINK” ^^ these are my settings for easy servoThanks to @Erer for the original model.