Phrozen Transform Fanport exhaust

thingiverse

I put some decent effort into it and created new brackets for the exhaust fan port. This is still just a test, I might need to install an exhaust fan to pull since I'm not sure if the existing fan can push all that way. Brackets are set up for a 4-inch diameter dryer machine hose. It needs two brackets, one for the left side exhaust fan port and one for the rear. Print these in black or paint them black, as the UV light makes them glow blue. Work in progress, use at your own risk. Edit 1: I made some adjustments to make it fit better. The hose barely clears the machine, so I'll be modifying it to give more clearance. I've updated the file to reflect these changes. Edit 2: I added a reinforced area for the extruded hose clamp to increase clearance room for the hose. I also included little slots for "rare earth magnets" so you can use them instead of double-sided tape. Additionally, I added a y-tube for two hoses to merge into one. Simplify3d says it doesn't need any supports, but I'm currently printing a test one. Edit 3: I updated the fan shroud and am fairly confident that this will be the last version I make for this file as it works very well and effectively! I've been testing extensively with its function and have found that this newest one works best. The parts I used to build my setup are listed below. Exhaust fan: https://www.amazon.com/VIVOSUN-Inch-Inline-Ventilation-Blower/dp/B01M7S46YZ?ref_=ast_sto_dp 10mmx1mm magnets: https://www.amazon.com/HAOYOYU-60Pieces-Refrigerator-whiteboard-Stainless/dp/B07G186TFS/ref=sr_1_11?keywords=HAOYOYU&qid=1580335027&sr=8-11 To assemble it, use a rasp to rough up the magnets and then super glue them into the holes. Use large strong zipties to hold the 4-inch dryer hose onto the fan shroud. That's about it!