Phrozen sonic Fume removal

cults3d

Warning: I dont believe that the optical sensor is soldered in the exatly same place for all the machines! It was designed specifically for MY phrozen sonic mini 4K. Put this adapter into the hole on top of the optical sensor and slowly (even by hand when the printer is turned off) move the Z axis and make sure the optical sensor can be switched!!! I dont take responsibility for destroying your printer. This is seal for phrozen Sonic mini 4K, that prevents the resin smell to come out of the printer. The printing area is not separated from the eletronic are, due to the hole for optical sensor. The result is, that the fumes are pushed through that hole into the eletronic a by ventilator pushed out. This adapter was made to seal the hole, leave just a little gap for the optical sensor to be switched. Use electrical tape to seal the adapter in place. (It should be sealed with that tape even to the optical sensor, so you must disassemble the top par of the printer, for the adapter to work right). After using this adapter all the resin smell is gone, since its traped in the printing area, just make sure to be in well ventilaed area, when you take the lid of the printer off.