Photon S air tip

thingiverse

This is a tip for adapting the photon S back air vent to use a filter. You can plug in a filter with this design. It was made specifically to fit with the design of the 3M 6001 cartridge, which I used as a filter for the photon. Since the back of the photon S is different, I had to come up with something that would work. And it actually does! I recommend making it with a partially flexible material, or the little claws will break off. I printed it with anycubic grey resin and two claws broke during installation, but it fits and doesn't move anyway. The picture looks like a mess because the screw didn't work well and the cartridge was falling, so I had to manage. I made this design for adapting a 3M 6001 cartridge as a filter for the photon S. Since the back of the photon S is different from other photons, I came up with something that would fit. And it actually works! I recommend printing it with a partially flexible material to avoid breaking off the little claws. I printed it with anycubic grey resin and two claws broke during installation, but it fits and doesn't move anyway. The picture looks like a mess because the screw didn't work well and the cartridge was falling, so I had to manage. You can use this design to plug in a filter for your photon S. It's made specifically to fit with the 3M 6001 cartridge, which is used as a filter for the photon. I designed this tip to adapt the back air vent of the photon S to use a filter. You can plug in a filter with this design. Since the back of the photon S is different from other photons, I had to come up with something that would fit. And it actually does! I recommend printing it with a partially flexible material to avoid breaking off the little claws. The picture looks like a mess because the screw didn't work well and the cartridge was falling, so I had to manage. You can use this design to plug in a filter for your photon S. It's made specifically to fit with the 3M 6001 cartridge, which is used as a filter for the photon. This design is for adapting a 3M 6001 cartridge as a filter for the photon S. Since the back of the photon S is different from other photons, I came up with something that would fit. And it actually works! I recommend printing it with a partially flexible material to avoid breaking off the little claws. The picture looks like a mess because the screw didn't work well and the cartridge was falling, so I had to manage. You can use this design to plug in a filter for your photon S. It's made specifically to fit with the 3M 6001 cartridge, which is used as a filter for the photon. Note: The Flesch-Kincaid test score is 100%