Photon S 50mm fan exhaust base

thingiverse

Now it's my turn on Anycubic Photon S ventilation. F360 document: https://a360.co/2BGphfj. I envisioned a design that would alter the printer as little as possible (no drilling) and be compact to boot. The plan capitalized on the fact that four rubber pads glued to the bottom plate can be removed, revealing small holes where my exhaust could attach. The exhaust leverages two 50mm fans - one situated inside the case and directed inward - plus a third fan I installed in the printer, which is also soldered to the main fan. The F360 design is parametric, allowing you to tweak it for bigger or smaller fans and exhausts (I used a 35mm pipe leading out of my window). If adjusting parameters doesn't do the trick, please chime in; I'll revisit the design. Both fans are soldered to the main fan, and the entire assembly was printed with PETG on 0.3mm settings.