Photon Door Prop

thingiverse

Alright, here goes: my Photon is under my desk. Because of this, I can't open the door far enough that it stays open while I'm fiddling around with things inside (getting the vat in/out, removing/installing the build plate, etc). I started using a stick, but after the umpteenth time I bumped the stick and had the door bust me one, I said forget it. A few minutes with a caliper, a ruler, and TinkCAD, and here ya go. This prop sits right up top Z assembly, keeping the door more or less at 90 degree. It's a quick print, only a couple of hours at 0.2mm layer height and 5% infill.