Phone Tripod Adapter

thingiverse

My Kids wanted to use the iPhone on our camera tripod, therefore I designed a simple cheap phone adapter which works well. I was originally going to make this spring loaded, but after putting it together it grips the iPhone 11 well with its cover. There is a small separation between the screen and fingers, where you can apply a thin foam strip if you wish. But it functions perfectly well without the foam. Prints in less than 2 hours without rafts and supports, and uses 6-7 meters of 1.75mm filament. Additional Hardware required: 3X M3 20mm Screws 3X M3 Nyloc Nuts 2X M3 12mm Screws 2X M3 Nuts Give it a go and enjoy.