Phone Trigger R1 L1

thingiverse

These triggers are R1 and L1 alternatives for phones. What You'll Need: Printed model A wire, approximately 5cm long with a diameter of no more than 1mm Aluminum foil Three pieces of double-sided foam tape A 1mm rod, 18mm in length How to Make It: 1. Print the model. 2. Attach aluminum foil to one side of each piece of double-sided tape and insert two wires, without insulation, into each piece. Before attaching the second wire, push it through a hole on one side if you want to make an L1 or R1 trigger. 3. Bend the two pieces after 8mm and cut them off. 4. Attach these two pieces to their slots. 5. Place the third piece in the arm's slot. 6. Push the rod into both printed pieces, applying gentle pressure if necessary.