Phone Stand with spot for charger

thingiverse

So I got a new phone with wireless charging, I had a charge pad, but I wanted to see the screen better whilst charging. This is the result of that. Measurements are based on my phone (iPhone XS), but it should work with a large variety of phones since they are all pretty much the same slab of glass with side buttons now (pretty much). The charger pad I have is a Spigen, basically square shaped. However, the design could accommodate larger models or round models. One note: my charge pad is a tad small and has very rounded corners, so it doesn't sit well. I used a little masking tape to hold it down - that works fine. If you have a supple cord, you could bend it beneath the stand. This are two mirrored halves. You will need to glue them. I hate printing with supports, so I split the model and made the two halves. I did not bother to add alignment pins; just be careful with the glue up. The model is rather thin - I wouldn't call this a robust design - but mine feels strong enough (and it cut down on printing time). Mine gets used every day ... and it has held up. **Is that a photo of a calculator?!?** Yes - The photo shows my calculator (HP 35s) in place of my phone (since my phone was the camera. The calculator is nearly the same size as my iPhone XS with a case ... just look at those beautiful buttons in all its RPN majesty!