Phone Stand (with built-in holes for charging cables)

thingiverse

I was approached by a friend to design something similar but with an open area at the bottom so they could easily pass cords through. I opted for a minimalist approach where the cables are only visible from the front for a brief moment. My original model, v1.1, had a similar design, but the ledge for the phone was too high and the bottom hole was as well, which led to some necessary tweaks to accommodate larger phones. All I can say is that if you decide to print this, make sure there's sufficient layer adhesion or bed adhesion, as it requires a 5-7 hour print and significant amounts of filament. Unfortunately, my first v1.2 (current model) suffered from severe cracking and splitting, resulting in the loss of 20 meters of filament. If you can successfully pull this off, then this is an excellent, practical print that you can use every day!