Phone Stand (with built-in holes for charging cables)

cults3d

I was asked by a friend to create one of these custom holders, but with open areas at the bottom for easy cord management. I opted for a minimalist design where only the front face showcases the cables. My original model (v1.1) shared a similar layout, but the ledge for the phone and the bottom hole were slightly too high. After tweaking and widening the design, it now fits larger phones comfortably. If you decide to print this holder, make sure to prioritize strong layer adhesion or bed adhesion, as it's a 5-7 hour print requiring significant filament usage. Unfortunately, my first v1.2 model suffered from severe cracking and splitting due to inadequate adhesion, resulting in a wasted 20 meters of filament. If you can successfully achieve the desired adhesion, this holder makes for a fantastic, practical accessory perfect for daily use!