Phone stand uses Costco Ubiolabs wireless charger

thingiverse

Phone stand that holds “inside” a Ubiolabs 10W charger found at Costco. https://www.costco.com/Ubio-Labs-10W-Qi-Wireless-Charging-Pad%2c-2-pack.product.100425275.html Stand is at a 71 deg angle (no glare from lights at my work desk). Has arms to hold phone in either profile or landscape. The arms are set at distances that optimize charging for a Pixel 6 Pro in a Rhinoshield case so your results my very on phone/cases. Indicating light of charger can be seen while phone is in profile. Printing info: *Supports will be needed for the center between legs. Arms do NOT need supports! So don't use auto generate. I printed with a 0.6 Nozzle, 0.3 layer height, 3 perimeter, 10% infill. Only the arms need the extra perimeters. Those settings with PLA took just over 3 hours to print. Feels very solid. I was lazy and had the whole thing at 3 perimeter, would be less time if setup for only the arms to have more. Probably can use less than 10% infill also but I haven't tested that. Other info: This is my 1st published creation to the public. There is still room for improvement. Inspiration in the creation of this came from mrheath12 design. His just didn't work for me though, so I made one from scratch (even a 3d model of the charger itself). Still thank you mrheath12 for the inspiration. Link to his below https://www.thingiverse.com/thing:4249792